Home Wi-Fi and network · Southwest Florida
Whole-Home Wi-Fi and Network Setup in Naples, FL
If you have to stand by the fridge to stream, the Wi-Fi is the problem, not the fridge.
NerdSquad designs and installs whole-home Wi-Fi and networks for homes across Southwest Florida. Strong coverage from the primary bedroom to the pool and lanai, a tidy equipment closet, smart devices kept on their own network and a local team that can restart things remotely when something freezes.
Coverage
House, lanai and pool
Equipment
Ubiquiti and WattBox
Security
Separate networks
Support
Remote and local
01 · Coverage
Wi-Fi that reaches every room, and the lanai
Southwest Florida homes are tough on Wi-Fi. Concrete block, stucco, tile roofs, long single-story layouts and a pool cage at the far end of the house all eat signal. A single router from the internet provider rarely covers it.
We design the network around the house: wired access points placed where you actually use the internet, a wired backbone between them and enough capacity for TVs, cameras, smart home gear and everyone’s phones at once.
📶
Wired access points
Ceiling or wall access points connected by cable, so coverage doesn’t depend on wireless repeaters.
🏊
Lanai, pool and dock
Outdoor-rated access points for the lanai, pool, guest house or dock, where streaming and calls usually fail.
📺
Wired where it counts
TVs, streaming boxes, office computers and the Control4 controller on cable for steady performance.
🗺️
Planned, then tested
We measure signal through the house after install and adjust placement and settings until it’s right.
02 · The equipment closet
One organized rack instead of a pile of blinking boxes
Behind every reliable home network is a closet you’d be happy to open. Here’s what a typical rack might hold.
U1
Internet provider modem
Your connection to the outside world
U2
Ubiquiti gateway and firewall
Routing, security and separate networks
U3
Ubiquiti PoE switch
Powers access points and cameras over one cable
U4
Patch panel
Every cable labeled by room
U5
WattBox power conditioner
Surge protection and remote restart
U6
Battery backup
Rides through short outages and flickers
Illustration: an example equipment rack. Every home gets equipment sized to the house and the systems in it.
03 · A safer home network
Your thermostat doesn’t need to see your laptop
A modern home can have dozens of connected devices: TVs, cameras, doorbells, speakers, thermostats, the pool controller. Each one is a small computer, and not all of them are well protected. We set up home networks the way we set up business networks.
Separate networks for family devices, smart home gear and guests
Cameras and smart devices kept away from laptops and phones
A guest Wi-Fi that’s easy to share and doesn’t open the rest of the house
Strong admin passwords and firmware kept up to date
Remote management secured with two-step sign-in
Parental controls and schedules where you want them
Working from home?
A home office can get its own network and wired connection, so video calls and work files stay separate from the TV and the smart speakers.
04 · Storm season
Getting the network ready before a storm
Summer storms and hurricanes are part of life here. A little preparation helps the network come back cleanly after power flickers and outages.
🔋
Battery backup
Battery backup on the gateway and switches keeps the network up through short flickers and gives equipment time to shut down cleanly.
⚡
Surge protection
Power conditioning on the rack and protection on outdoor equipment, where lightning-related surges often get in.
🔁
Remote restart
WattBox outlets let us power-cycle a frozen modem or access point remotely, without a visit.
📋
A simple storm checklist
What to unplug, what to leave on and how to bring things back up in the right order.
No equipment can keep a network running through a long power or internet outage. Preparation helps it come back faster and with less trouble afterward.
05 · After install
A local team that knows your network
Once the network is in, we can keep an eye on it and help when something isn’t right, often without a visit.
01
Walkthrough
We walk the house, check where coverage drops and ask how you use each space.
02
Design and proposal
A written plan showing access point locations, wiring and equipment.
03
Install and label
Cabling, access points and a labeled rack, installed neatly.
04
Test and tune
Signal measured through the house and settings adjusted until it’s right.
05
Hand-off
Wi-Fi names and passwords documented, guest access set up, the household shown the basics.
06
Ongoing help
Remote restarts, settings changes and local visits when something needs hands.
Away for the season?
We can check on the network remotely and restart equipment so cameras, the thermostat and the smart home stay reachable while you’re gone.
06 · Questions homeowners ask us
Home Wi-Fi and network FAQ
Why is my Wi-Fi bad in parts of my house?
In Southwest Florida it’s usually the construction. Concrete block, stucco and tile block Wi-Fi signals, and long single-story homes put rooms far from the router. Wired access points placed through the house fix it more reliably than repeaters.
Can you get Wi-Fi to my pool, lanai or dock?
Usually, yes. We use outdoor-rated access points and run cable where possible, so coverage reaches the pool, lanai, guest house or dock.
What equipment do you use?
We design most home networks with Ubiquiti equipment and use WattBox for power protection and remote restart. If you already have equipment, we’ll tell you what’s worth keeping.
Is mesh Wi-Fi good enough?
For smaller homes, mesh can work well. In larger homes or block construction, wireless mesh links lose speed. Access points connected by cable are more consistent, and we can often run cable without much disruption.
Why should smart devices be on a separate network?
Cameras, TVs and smart home devices don’t always get security updates. Keeping them on their own network means a weak device can’t easily reach your laptops, phones or files.
Can you fix my network remotely?
Often. Many settings changes and equipment restarts can be done remotely when the network is set up for it. When something needs hands, we come out.
Will my internet work during a hurricane?
That depends on power and your internet provider. Battery backup and surge protection help the network ride through short outages and come back cleanly, but no home equipment can keep the internet running when the provider’s service is down.
How much does a whole-home Wi-Fi system cost?
It depends on the size of the house, the construction and how much cabling is needed. We don’t publish one-size prices. After a walkthrough we give you a written proposal.
More for your home
Everything else in the house runs on the network.
Where we work
We’re based in Naples. We install and support home systems across Southwest Florida:
Naples · Marco Island · Bonita Springs · Estero · Fort Myers · Cape Coral
Running a business?
The same team runs managed IT, cybersecurity and help desk support for Southwest Florida businesses.
Last step · Book a walkthrough
Let’s fix the Wi-Fi for good
Tell us about the house and where the internet lets you down. We’ll walk it with you and come back with a written plan.
Coverage planned for the house, lanai and pool
A labeled, organized equipment closet
Remote help and local visits after install
NerdSquad Managed IT Services · Naples, FL · 239-465-0079
Tell us about your home
A real person reads every message. Please don’t send passwords or alarm codes.
